I want to connect VPN between my two offices. It was working fine but after some power failure we had to restart the router but then the router is working but VPN is not connecting. i have the following scenario between my two offices:
The VPN tunnel continuously shows Waiting for connection at both ends. I can see the packets of VPN intial mode at one site but there are no VPN logs at other site.
My other VPN box is working perfectly. I tried to configure a VPN tunnel with my other Rv042 box and it works fine. but this one is not working fine. and is not showing any VPN logs. Does anyone knows where is the issue.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...