I'm old fashioned. With my old Cisco 3620 routers, I could easily go into emacs and type a config by duplicating records and changing one or two characters. Then I could download the config to the router and reboot.
With the RV042G, I would like to do the same. However, when I save the startup config file, the resulting file is not editable. Is there a way to convert it to something I can edit?
Please note that adding rules to the firewall is very cumbersome in the browser as it defaults all of the entries after each rule is added when, at least for me, I only want to change the port from rule to rule - and when I enable to second WAN, I will want to copy all of the rules again and just change WAN1 to WAN2.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...