08-12-2014 01:03 PM
Hi,
I have a RV042G and using 2 differnet internet provider
Here is the question, is there any way to setup like some of the service are using WAN1 and some service are using WAN2
thanks
08-12-2014 10:46 PM
Hi,
yes, you can do that using protocol binding under system mangement---->Dual wan menu.
Note:Configure router in Load balance mode under system mangament.
More info:check the admin guide:
http://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/rv0xx/administration/guide/rv0xx_AG_78-19576.pdf
regards
Moorthy
08-27-2014 09:02 AM
Hi, I did try to set in Bandwidth Management
Type: priority
Interface WAN1
Direction: Upstream
Prority: High
Enable
but when I select load balance the IP will change it to WAN2 ext IP, and this service seem like not working, but I changed it to use WAN1 as the main, its work again
so, i can not use load balance... and i only can use WAN1 to let the service work...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide