Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RV042G dual wan problem

Hi,

I have a RV042G and using 2 differnet internet provider

Here is the question, is there any way to setup like some of the service are using WAN1 and some service are using WAN2

thanks

2 REPLIES
Bronze

Hi, yes, you can do that

Hi,

 

yes, you can do that using protocol binding under system mangement---->Dual wan menu.

 

Note:Configure router in Load balance mode under system mangament.

 

More info:check the admin guide:

http://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/rv0xx/administration/guide/rv0xx_AG_78-19576.pdf

 

regards

Moorthy

Community Member

Hi, I did try to set in

Hi, I did try to set in Bandwidth Management

Type: priority

Interface WAN1

Direction: Upstream

Prority: High

Enable

but when I select load balance the IP will change it to WAN2 ext IP, and this service seem like not working, but I changed it to use WAN1 as the main, its work again

so, i can not use load balance... and i only can use WAN1 to let the service work...

97
Views
0
Helpful
2
Replies
CreatePlease to create content