Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RV042G - Unable to Access Internal Website from Web

I've just set up this RV042G as a gateway.

Comcast modem is in Bridge mode

I've enabled One-to-One NAT

Private Range:  10.1.10.141

Public Range:  50.197.xxx.xxx

Range Length: 1

Where 10.1.10.141 is a Web Server on our network

Set up "Access Rules":

Priority: 1

Allow HTTP (80)

Source Interface:  WAN1

Source: ANY

Destination: 10.1.10.141

Time: Always

Unable to access this website from the web.

Can ping the gateway router.  no problem

(When Block WAN Request is disabled)

I'm likely missing another setting.

Any help is greatly appreciated.

Many thanks

1 REPLY
Bronze

RV042G - Unable to Access Internal Website from Web

Hello Randy,

I feel the router's IP address has been changed. Try connecting your PC directly your router and go to Network and Sharing Center > Ethernet and click details (Assuming that you are on DHCP and not on any Static IPv4 address -> Ethernet). You may see your routers IP address as the gateway. If it doesn't work, disconnect the internet from router and try the same steps again.

Hope this helps,

Thanks,

Vijay

209
Views
0
Helpful
1
Replies
CreatePlease to create content