RV042G - Unable to Access Internal Website from Web

[randyengle]

I've just set up this RV042G as a gateway.

Comcast modem is in Bridge mode

I've enabled One-to-One NAT

Private Range:  10.1.10.141

Public Range:  50.197.xxx.xxx

Range Length: 1

Where 10.1.10.141 is a Web Server on our network

Set up "Access Rules":

Priority: 1

Allow HTTP (80)

Source Interface:  WAN1

Source: ANY

Destination: 10.1.10.141

Time: Always

Unable to access this website from the web.

Can ping the gateway router.  no problem

(When Block WAN Request is disabled)

I'm likely missing another setting.

Any help is greatly appreciated.

Many thanks

[vvijaysa]

Hello Randy,

I feel the router's IP address has been changed. Try connecting your PC directly your router and go to Network and Sharing Center > Ethernet and click details (Assuming that you are on DHCP and not on any Static IPv4 address -> Ethernet). You may see your routers IP address as the gateway. If it doesn't work, disconnect the internet from router and try the same steps again.

Hope this helps,

Thanks,

Vijay