RV082 and RV016 bandwidth control of ipsec tunnels
I have a network setup with a hub & spoke configuration using the RV series routers. Due to the fact that bandwidth varies by site and is precious, is there any ports other than UDP 500 that need to be used for allocating the traffic levels?
It is not very clear to me what exactly you are trying to configure, maybe you can share more details, but to answer directly to your question - port UDP 500 and UDP 4500 are used by IPSec only to establish the VPN tunnel and renegotiation when the SA lifetime expires. The traffic is transferred by ESP packets.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...