This thread is specific to CISCO software development and support teams. I use both RV082 and RV042 VPN routers. This router should provide administrator control for each port that can enable or disable internet access under the "PORT MANAGEMENT" tap. It only has internet enable/diasble for entire router. As an admin, I would like to grant certain port ID for internet access while other port IDs are disabled for internet, and at the same time LAN is fully functional. This function is really necessary to prohibit unauthorized users accessing internet during work hours.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...