Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RV082 Firewall Access Rules not work

Serial Number :NKS16470063Firmware Version : v4.2.2.08 (Apr 26 2013 19:12:26)
PID VID : RV082 V03Firmware MD5 Checksum : 9f4450cc2cc023dc0e9d6aef842afd48
LAN
Working Mode : Gateway

IPv4/ Subnet mask : 192.168.1.1/255.255.255.0

dear all

when making an access rules on my gateway i don't effect

ex.

Action : Deny

Service : All Traffic [1]

Log :           log packets match this rule

Source Interface : ANY

Source IP :           192.168.1.139

Destination IP :           any

Scheduling 

Time : Always

the pc with this IP still can access the internet

plz help me i want to Prevents some PCs in my net work from access internet

2 REPLIES
Green

RV082 Firewall Access Rules not work

***I DO NOT RECOMMEND TO DO THIS DURING BUSINESS HOURS IF PEOPLE ARE WORKING OR SOMETHING GOES WRONG***

Hi Arsanius, I think the problem is, your firewall rule does not over write the default state table. Meaning, the default rules specifically say allow traffic from LAN to WAN.

So you should nullify the default state table first by making a general rule that says-

Action Deny

Service All

Source interface ANY

Source IP any

Destination IP any

Save

Then you can make your permit rules to permit people to use the internet.

Action Permit

Service ANY

Source interface LAN

Source IP -xx.xx.xx.xx

Destination IP - xx.xx.xx.xx

Save

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

RV082 Firewall Access Rules not work

Thank's tom for your reply i discover the problem not just the router did not accept any rule only but also when i tried to control it from  Bandwidth Management by reducing the speed for the PCs that i  wanna Prevents them from the internet the roter also did't act well , but finally i hade an idea that i pressed the Factory Default Buttons not from the software but from hardwear and made the same setting again the router acting well .

Remark :-

That problem happened suddenly the roter was working well and when i was making a new rule i discovered that the router stop acting for any rule and i investigate and i have find it stoped acting from couple days and all the PCs in the work connected to internet

so thank you again but i don't know why it stop acting and when i reset it work good

424
Views
0
Helpful
2
Replies
CreatePlease to create content