We have an older (version 1) RV082 running firmware 1.3.6. After upgrading to firmware 2.0.2.01-tm the web management would not work (page not available). Even though the web management was not working the configured VPNs were working. After resetting the router to factory defaults web management returned, but it stopped working as soon as I restored the router configuration.
I ended up reverting to the older firmware and restoring the router settings.
1) Is there a router setting I should change before upgrading in order to enable web management?
2) In the event I need to replace the router is there a utility that will convert the saved configuration file? I have found mention of a conversion utility but it seems to have disappeared from the Cisco web sites.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...