I have two RV082 (hardware version 2, firmware 2.0.2.01-tm) routers at two different sites in town. I am trying to get the gateway to gateway VPN connection to work reliably. After I first connect the tunnel all works well for about 1 minute. I can ping machines on each network from the other network and my tunnel always shows as being connected in the interface on each router. Then, usually after around 1 minute, i am unable to ping from either gateway to the other and vice versa. I used all the default values when setting up the tunnel. I have tried every option I can think of to fix this. Anyone else had or having this problem?
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...