i have 1 head office ( rv082 ) and about 14 branches (13 rv042 and 1 rv082 ) which are connected by VPN Tunnels. About 2 weeks ago my primary RV082 starts FAILs about 2-3 times in a week, but in local network i can connect to it.
Tell me please what should i do to fix it, and what the problem is ?
I think i have the exact same issue... How do you know its going down? By looking at the uptime? for some reason my uptime counter is never high it always resets randomly. Whenever i look in the panel the uptime will read like a few hours when it should read a few weeks..
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...