I have an RV082 installed at a client's workplace. They have dual internet connections, which work fairly well.. Today the DHCP server stopped leasing out IP addresses. Router responded to ping, but wasn't accessible by WebAdmin. Internet continued to work for workers whose computers hadn't hibernated over their lunch break. Power cycling the device immediately fixed the problem. We had this EXACT problem almost exactly a month ago, with power cycling being the only fix.
Any ideas? The firmware is the latest offered (18.104.22.168-tm), and it seems to work fine otherwise. If this continues it would seem to me that it's a hardware problem that would be easily fixed by replacement. The router is only 6 months old.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...