I was wondering if somebody could give a link for instructions on how to use the "backup" VPN feature on a RV082 router.
Currently we have a gateway-to-gateway VPN established between two RV082 routers in two different locations (using only one WAN port on each). We are looking into getting an additional internet connections for each site to minimize downtime (hence beging using two WAN ports on each site). However, I have tried several ways to get the backup VPN feature to work with no luck.
I see when I go to the "Advanced Options" for a VPN tunnel that you can specify a backup VPN, but I'm not sure how to configure this and all the documentation that I have seen seems pretty vague on the subject. Any ideas?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...