I recently purchased a RV082 for a factory to replace the home qualtiy Linksys router that they were overloading. I hooked up the new router and switched it from a gateway to a router. The router gets an IP, gateway and DNS from our ISP(wildblue) and is recieving packets but computers on the network are showing no internet connecting. I checked under the diagnostics and the router can resolve names to ip addresses but it fails the ping test everytime. Computers on the local network can ping each other. I tried disabling the firewall but it didn't have any effect.
I thought maybe the internet was down but after reinstalling the old Linksys router, all the computers were able to get online. Does anybody have any suggestions for what I should try next?
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...