I've seen discussions about people making reliable VPN connections from an RV082 at a remote site to a Cisco ASA 5500-series security appliance in a home office. Can we get a FAQ/document showing settings on both sides to make this work? Even if you mark it as "This is an unsupported configuration, use at your own discretion" it would be better than nothing. Every Cisco device, Linksys or otherwise, should be able to communicate with other devices, especially over industry standard IPSec protocols.
My ASA5510 --- RV082 is down right now (the RV082 got hit by a power surge) but when it's back up I'll review the config if you're still in need of help. I do remember that I had to set the Dead Peer Detection time on the RV082 to match that of the ASA for it to come up. I think the default on the ASA is 10 seconds, but the default on the RV082 is 30 seconds? Not sure, but I know I had to make those match before it came up.
If you don't mind waiting - it'll be a couple of weeks. My partner is going to be installing it next week or the week after. I'll be on vacation the end of next week. As soon as I have connectivity to it again, I'll let you know.
Configure DHCP WAN Settings on the RV34x Router
A Wide Area Network (WAN) is a network that covers a broad area. A user or network of users can connect to the Internet through an Internet Service Provider (ISP) who offer...
Configure Static IP WAN Settings on the RV34x Router
A Wide Area Network (WAN) is a network that covers a broad area. A user or network of users can connect to the Internet through an Internet Service Provider (ISP) who ...