Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Rv082 wan 2 bridge with verizon DSL

I have the Cisco RV082 with firmware v4.0.4.02

Comcast is connected to Wan 1 and works perfectly.

I've enabled load balancing and am trying to get verizon DSL to function on wan 2.


My verizon DSL line is connected via their provided actiontec GT784WNV router.

I've enabled transparent bridging on the actiontec router and have PPPOE set up in Wan 2 on the RV082.

Wan 2 shows the following information, but will not connect to anything.

IP Address :           108.34.xx.xx

Default Gateway :           10.4.53.1

DNS :           71.242.0.12

Dynamic DNS :           Disabled

I'm able to ping and traceroute most sites.

What is the problem here?

2 REPLIES
Hall of Fame Super Gold

Rv082 wan 2 bridge with verizon DSL

Wrong forum, try "small business - routers". You can move the post using the control panel on the right.

Rv082 wan 2 bridge with verizon DSL

You need to enable load balance at the

System Management>Daul WAN page. The default is smartlink backup, which uses one WAN at a time.

1057
Views
0
Helpful
2
Replies
CreatePlease login to create content