Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RV110W- Apply Access Rules

I have an issue with Single Port Forwarding on these units.

I wanted to try Access Rules as a workaround.

When I set an Access Rule for, let's say, HTTP and point it to an internal IP, when I try browse to the address, I get the router maanagement page instead. This puzzles me as the router is a different IP, and does not have HTTP enabled for management.

If I set an Access Rule for FTP, the connection attempt is blocked.

So, anyone using Access Rules for inbound traffic? Is it possible? How are you configured?

Thanks

1 REPLY
Silver

RV110W- Apply Access Rules

Please contact the Cisco Small Business Support Center and open a support case with next available engineer @ 1-866-606-1866

Jasbryan

827
Views
0
Helpful
1
Replies
CreatePlease to create content