Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RV110W VLAN Configuration

I am trying to create a simple 2-VLAN configuration on an RV110W.  After adding the VLANs, I am unsure how to specify whether the port traffic should be tagged, untagged or excluded.

On the VLAN Membership page, I want VLAN 3 associated with ports 1,2 and 3.  I want VLAN 4 associated with port 4 only.  I want both VLANs to have access to the internet, and I want the VLANs to be isolated from each other.

The VLAN Membership page looks like this:

VLANs Setting Table
SelectVLAN IDDescriptionPort 1Port 2Port 3Port 4
1DefaultUntaggedUntaggedUntaggedUntagged
3WEITaggedTaggedTaggedExcluded
4JEMExcludedExcludedExcludedTagged

Using these configuration options does not prevent computers on oneVLAN from accessing shares on the the other VLAN.  What do I need to change?  (The computers in this configuration are connected to dumb switches, which are connected to the LAN ports on the RV110W .)

Everyone's tags (2)
1220
Views
0
Helpful
0
Replies
CreatePlease to create content