I have two sites which each have RV110W behind DSL modems. The RV110W's are looking for ID_INFORMATION relating to the DSL IP Address as that is the end of each tunnel, but they are sending their WAN IP address as ID so they don't match up. How do you configure around this? There must be an example of it somewhere but I cannot find it in any searching!
I had the tunnel up when I had replaced only one of my old routers - the old Zyxel router VPN premitted manually configuring the ID so I could get a tunnel up until I replaced the second router. As an aside however I couldn't pass traffic for some reason....
I always put the DSL modems in transparent bridging mode and terminate PPPoE/PPPoA on the router/firewall to avoid problems like this. Last I checked, that particular router doesn't allow you to have an identity address different from the peer address.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...