I never had to block a site, but now i have to. I wanted to make it through "Internet access policity" but it gave me a message: "You must set at least one access rule". Ok i done it, but it still gives me the message. Maybe i missed a step, but it's funny, because before i updated the firmware i can't set any rule. So i updated. Now i have another problem. How do i solve it?
The reason why you're getting that error message is because you haven't entered anything on "Appy Access Policy to the Following PCs" field, you need to specify either a MAC address, specific IP or IP range, otherwise the router won't know what end devices it should apply the rule to.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...