RV120W Port forwarding with port mapping does not seem to work.
I am trying to connect from the Internet through the WAN port on the router and have it forward port from 8081 on the WAN IP to port 80 on an internal device IP. I have this set up in port forwarding and it does not work. I am on the latest firmware 220.127.116.11.
I have seen some suggestions that port forwarding does not work and that I should use firewall rules instead of port forwarding rules, however firewall rules do not seem to let you forward from an external port that is different than the internal port you are forwarding to.
This worked fine on the old Dlink router that I am replacing with this Cisco router.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...