RV120W unresponsive following upgrade. Next steps?
I recently upgraded my RV120W firmware from 22.214.171.124 to 126.96.36.199. While the upgrade appeared to occur normally, once complete the login page did not reappear. Following a manual reboot using the on/off switch, I can no longer contact the router nor will any device recieve an IP address. Wireless is also not functioning although the light is on. The power light was slowly blinking, although it settles down to steady. Depressing the reset button has no apparent effect on the operation. Are there any next steps I can try to attempt to recover the router? Thanks!
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...
Article ID:541 Firmware Upgrade on RV016, RV042, RV042G, and RV082 VPN
Routers Objective To upgrade the firmware, a specific file must be
downloaded from the Internet and uploaded to the device. Firmware
upgrades can fix software bugs, improve features, a...