I have two sites each with a Cisco RV120W Router. My objective is to establish a VPN between the two routers so we can map a shared drive between both locations. I have been successful in getting the IPsec tunnel established between the two locations and can remotely log into the far end router with no issue.
The problem I'm having is I can't access the far end PC. I am not using PC names but rather their local IP address. It's like the router is not passing traffic to the remote PC.
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...
Article ID:541 Firmware Upgrade on RV016, RV042, RV042G, and RV082 VPN
Routers Objective To upgrade the firmware, a specific file must be
downloaded from the Internet and uploaded to the device. Firmware
upgrades can fix software bugs, improve features, a...