Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RV130 IPv6 /48 and /64 scopes locks up router web interface

I wanted to use the IPv6 DHCP server to hand out addresses for other subnets
It wont let you add scopes that are not part of the Lan IP, So I used a /48
and then used /64 for the scopes

After I saved it, the web interface was no longer accessable
though I could ping the routers IPv4 and IPv6 addresses
I can NOT access the web interface, and had to reset to factory defaults to get it working again

 

  • Small Business Routers
Everyone's tags (1)
1 REPLY

Hi phibetron,You seems to be

Hi phibetron,

You seems to be doing some tests with RV130 and some of your concerns required verification. I would strongly encourage you to contact Cisco Small Business Support team and open tickets:

http://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html

Regards,

Aleksandra

116
Views
0
Helpful
1
Replies