06-19-2018 11:57 PM - edited 03-21-2019 11:11 AM
Hi,
We have hundreds of Cisco Small Business routers, WRV210, RV120W and RV130W. On the first two models there is an option at IPSec Tunnel creation to redirect all traffic via the tunnel. At "local traffic selection" we select "any" and all traffic goes to tunnel where is filtered by firewall and restricted.
On RV130W there isn't the "any" option at "local traffic selection" and doesn't allow to input 0.0.0.0/0
We've tried with older and newest firmware versions and no luck.
Is there any other way on RV130W to redirect all traffic on VPN tunnel?
Solved! Go to Solution.
06-20-2018 10:56 AM
Hi,
My name is Iliya Gatsev from Cisco Technical Support Team.
On RV130 there is no "any" option at "local traffic selection" and it doesn't allow to input 0.0.0.0/0
It is not supported.
Please rate this post or marked as answered to help other Cisco customers.
Iliya Gatsev
Cisco STAC Network Engineer
Together we are the human network .:|:.:|:. CISCO
06-20-2018 01:40 AM
Hi,
My name is Rozana and i am an engineer from the SMB team.
We have tested to create 2 tunnels, breaking the 0.0.0.0/0 into two subnets as a workaround to the restriction ( 0.0.0.0/1 and 128.0.0.0/1). This is set as a Remote LAN subnet.
The tunnels are established, but the clients report connectivity issues.
You could also try this workaround, but have in mind that officially the RV130 does not support the option you seek, and therefor all workarounds might cause issues.
Regards.
06-20-2018 03:35 AM
Thank you Rozana,
It's a good workaround but my LAN on these routers is 10.x.x.x and doesn't allow me the first segment if I set first VPN tunnel as 1.0.0.0 with subnet mask 128.0.0.0 since it's included here. This means I need to split in 3 tunnels... This means changes on ISR as well.
We will discuss and I think we will search for another equipment.
Thanks!
06-20-2018 10:56 AM
Hi,
My name is Iliya Gatsev from Cisco Technical Support Team.
On RV130 there is no "any" option at "local traffic selection" and it doesn't allow to input 0.0.0.0/0
It is not supported.
Please rate this post or marked as answered to help other Cisco customers.
Iliya Gatsev
Cisco STAC Network Engineer
Together we are the human network .:|:.:|:. CISCO
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide