Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

RV180 blinking or flashes on Power LED and Wireless LED

I have a new router RV180W, the problem is show up after I configure  RV180W for the first time after I reboot the router. The LED Power and  Wireless is blinking or flashes so I can't access my router via LAN  Port. I try to reset to factory defaults by press the reset button but  it still doesn't work. Help me to fix this problem what should I do ?

5 REPLIES
Gold

RV180 blinking or flashes on Power LED and Wireless LED

Dido,

Hold the reset button for 12 seconds with the router powered on. It should reset to factory defaults.

- Marty

New Member

RV180 blinking or flashes on Power LED and Wireless LED

I have the same problem on my Cisco WRV210 when I enabled WMM it completely locked and I cant access it via Lan and the wireless isn't turning on even the reset wont work.

Gold

RV180 blinking or flashes on Power LED and Wireless LED

Alvaro,

From the WRV210 Quick Start Guide:

• Factory reset—Press the button for approximately 15 seconds to reset

the router to the factory default settings. You can also restore the

factory default settings from the Administration > Factory Defaults page

in the web-based Configuration Utility.

Try that and see if it will reset. If not, post your serial number or call support to see if your device is under warranty.

www.cisco.com/go/sbsc

- Marty

New Member

RV180 blinking or flashes on Power LED and Wireless LED

Serial Number is GSZ15140000

Gold

RV180 blinking or flashes on Power LED and Wireless LED

Alvaro,

Covered under warranty

Please call support for assistance.

www.cisco.com/go/sbsc

- Marty

1243
Views
0
Helpful
5
Replies
CreatePlease to create content