Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

RV180 Static Route Configuration

Good Evening,

  I have a RV180 router which I need to install into a rack in a 3rd party datacentre.

  The RV180 is to replace an ageing Draytek.

  The purpose of the router is to connect my VM host to the another of my servers which is located within the same datacentre but on a different network.

  The existing Draytek has the following configuration - IP's changed for safety:

  WAN IP: 152.96.0.2

  Subnet Mask: 255.255.255.0

  Gateway IP: 152.96.0.1

  DNS IP: 8.8.8.8

  MTU: 1442

  LAN IP: 192.168.80.1 (The Routers IP)

  Static Route #1:

  Destination IP: 192.168.78.0

  Subnet Mask: 255.255.255.0

  Gateway IP: 152.96.0.1

  Interface: WAN

  Static Route #2:

  Destination IP: 20.8.100.0

  Subnet Mask: 255.255.255.254

  Gateway IP: 156.96.0.1

  Inteface: WAN

  When I set this configuration on the RV180 it is unable to ping my server in the 192.168.78 network or any external IP - such as 8.8.8.8.

  I can only ping servers inside of the 156.96.0 network.

  I have the latest firmware: 1.0.3.10.

  I have made sure the static routes are enabled.

  I have added inbound & outbound firewall rules to allow all traffic.

  I have set the router in NAT mode.

  What am I doing wrong?

Regards

Rob

140
Views
0
Helpful
0
Replies
CreatePlease to create content