Rv180w and rv042 IPsec VPN tunnel windows file sharing
I have two locations one running a cisco rv180w and the other running a cisco rv042. I have an IPsec tunnle between both locations.
Each location can ping each other and the rv042 location is able to access windows share from the rv180w location. Howerver, the rv180w location is not able to access shares on the rv042 location.
I tried access the share by IP and by name after editing the host file with no luck.
Windows firewall is disabled on both locations.
Also when I do a port scan of a windows box from the rv180w location to the rv042 location all the ports are blocked but when i do a port scan from the rv042 location to the rv180w location 135,39,445 are open. When i do a scan from the internal network of rv042 the ports are open.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...