Trying to setup WOL and RDP only for a specific device on the network.
Have setup that device with IP MAC Binding and Static IP on the router.
Created custom services with correct port numbers.
Added access rules.
Added port forwarding.
When I check to see if the ports are open via http://www.yougetsignal.com/tools/open-ports/ it tells me that the port is closed. This despite doing the same exact setup for another device on the network and those ports being shown as open and all services working.
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...