Hi Joseph, what kind of wireless are you using? Like a Verizon Hotspot or something? This may be very relevant. Also, whatever wireless connection is servicing for a LAN IP? Is it different than your RV180? What is your download/upload speed on the wireless connection? What kind of VPN do you use? IPsec or PPTP? What client? QVPN or something else?
-Tom Please mark answered for helpful posts
Please mark answered for helpful posts
Hi Tom, thank you for your response, basically it was ReyEye IR controller with PPTP connection, very strange, it is abled to ping while not able to connect it. I am using HK boardband & it should no restrictions, up/download is arround 30mb. There is no issue on all the LAN device connection, i wonder LAN & wireless are connected with difference valn in RV180.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...