Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RV215W IPSEC VPN tunnel RV180W using FQDN

Need some assistance....

I was able to configure these routers using static IP's without any issue on my inhouse network.

Client doesn't want to pay for Static, so have setup DYNDNS account.

so have setup advanced IPSEC with FQDN

getting initial handshaking so they are seeing each other, but Tunnel does not establish.

from log get error on PHASE 1

"invalid sa protocol type 0"

Any suggestions, or documents I should be looking at to get the IPSEC VPN established.

 

Thanks in advance.

Simon 

2 REPLIES
Hall of Fame Super Gold

Duplicate posts.   Go here:

Duplicate posts.  

 

Go here:  http://supportforums.cisco.com/discussion/12200576/rv215w-ipsec-vpn-tunnel-rv180w-using-fqdn

Bronze

Try putting in the dyanmic

Try putting in the dyanmic IPs as static and see if that works.  If so, then you at least know it's something related to the FQDN/Dyndns setup.
 

Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com
186
Views
0
Helpful
2
Replies