Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

RV220W - After creating a VPN connection, is it necessary manually create routing protocols so that traffic destined for the VPN network goes across the tunnel?

I have successfully build my tunnel, but I cannot seem to get traffic to flow across it to the corporate network on the other side of the tunnel. Is it necessary to create any routing information so that work flows?

2 REPLIES
Cisco Employee

RV220W - After creating a VPN connection, is it necessary manual

Traffic will still have to be routed just like a standard WAN link.  Static routes or a dynamic protocol must be used to route your traffic accross the tunnel.

Regards,

Tom

RV220W - After creating a VPN connection, is it necessary manual

It's not needed to add additional routes if the traffic is between the two subnets defined in the VPN policy.

602
Views
0
Helpful
2
Replies
CreatePlease to create content