Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

RV220W not working with the PPTP server on one VLAN only

Hello,

I possess a RV220W (firmware 1.0.3.5) but I can't seem to work with the PPTP server on one VLAN only.

My default VLAN is in 192.168.1.1/24.

I created a VLAN ID 10 in 192.168.50.1/24 inter-vlan routing : disabled and Device Management : disabled.

(Menu Networking > LAN > VLAN Membership and Multiple VLAN Subnets).

Then I configured a PPTP server on the IP range 192.168.50.200 to 192.168.50.210.

To finish I created my user.

(Menu VPN > IPSEC > VPN Users).

The PPTP tunnel is working, but on all my local network and not only the VLAN ID 10.

An idea??...

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions

RV220W not working with the PPTP server on one VLAN only

This seems to be a limitation of firmware 1.0.3.5. Firmware 1.0.4.x will support inter-VLAN access rules, which hopefully can be used to restrict traffic to the default VLAN from your VLAN ID 10.

3 REPLIES
New Member

RV220W not working with the PPTP server on one VLAN only

HI,

Nobody can tell me if the RV220 PPTP server is able to work on a specific VLAN??.

RV220W not working with the PPTP server on one VLAN only

This seems to be a limitation of firmware 1.0.3.5. Firmware 1.0.4.x will support inter-VLAN access rules, which hopefully can be used to restrict traffic to the default VLAN from your VLAN ID 10.

New Member

RV220W not working with the PPTP server on one VLAN only

Thank you tekliu,

I eagerly awaiting the release of firmware 1.0.4.x

cordially

Thierry

1392
Views
0
Helpful
3
Replies
CreatePlease to create content