RV220W Reverts to 10/100 on lan ports to Gigabit switch after some time.
I have an RV220W in router mode, with a cat5e cable plugged into a GS108Tv2 and every now and then my whole network becomes slow. I traced the issue down to the RV220W port on the GS108Tv2, it slows down to 10/100 instead of 10/100/1000, is the router programmed to do this automatically after some time of no activity?
Because I only use the RV220W as a backup wifi access point, so usually there's no traffic on it.
Is there a setting to change this from happening, because it's awfully disruptive to my whole network, since the switch causes all traffic down to 10/100 when this happens.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...