1 - My LAN IP network is 172.18.x.y/16 -- is there any way to set the RV320's IP address as 172.18.100.235 ? I could not find it ....
2 - VPN -- I have IPSEC VPN's working between Cisco 2901, 1841, and 1711. I would like to copy the VPN config section from the "old" routers to the RV320 -- is there a way to get into the RV320's via telnet or ssh ?
3 - When I try to activate an IPSEC VPN the 320 seems to want to make it an SSL VPN. Im getting message regarding some sort of OAKLEY negotiation. The messages go away when https is turned off in the firewall settings at which point administration also reverts to http.
Please help ! Im trying to avoid having to return this router.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...