We install a new network with a RV320, a HP switch 1910-8G and an access point TP-Link TL-WDR4900 which was our old routeur.
Main network is 192.168.1.0/24
We created 2 vlans, id 10 192.168.10.0/24 and id 20 192.168.20.0/24
Each windows or mac client connects to wifi ap with an SSID and a wpa2 key. RV320 is providing all informations related to the vlan, give an ip address with dhcp, give gateway and dns server. We do not have problems with thoses clients, like with tablets, iphone or android.
When we tried connection with linux client, it didn't work.
Here is the log with a archlinux client using netctl and dhcpcd client.
juil. 29 14:22:18 shikoku dhcpcd: timed out juil. 29 14:22:18 shikoku dhcpcd: exited juil. 29 14:22:18 shikoku network: DHCP IPv4 lease attempt failed on interface 'wlp3s0' juil. 29 14:22:18 shikoku kernel: wlp3s0: deauthenticating from f8:1a:67:5a:54:12 by local choice (Reason: 3=DEAUTH_LEAVING) juil. 29 14:22:18 shikoku kernel: cfg80211: Calling CRDA to update world regulatory domain juil. 29 14:22:18 shikoku network: Failed to bring the network up for profile 'CoworkInMontpellier' juil. 29 14:22:18 shikoku systemd: netctl@CoworkInMontpellier.service: main process exited, code=exited, status=1/FAILURE juil. 29 14:22:18 shikoku systemd: Failed to start Networking for netctl profile CoworkInMontpellier. juil. 29 14:22:18 shikoku systemd: Unit netctl@CoworkInMontpellier.service entered failed state.
With wireshark we saw the dhcp request from linux to router, but we did not receive the ACK response.
We connect the linux client directly to the RV320 with an ethernet cable. And we retried to connect. Same issue.
If we configure the client connection with a static ip address 192.168.10.19, the router address as gateway and dns server 192.168.10.1, the client was connected and could browse the network and internet.
So we tried the same configuration with the wireless interface, and it worked.
We have 2 linux clients, one with archlinux, the other with ubuntu and we have the same effects. We can connect with static ip, but not with dhcp.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...