RV320 Dual wan setup, wan2 keep disconnecting after a few mins.
I have just switched out our offices rv120w for a rv320. I have set it up for dual wan with fail over. Both WANs are on static ip's. I have the settings working separately, but if i connect both connections to both WAN ports, WAN2 keeps dropping its connection.
It will show in the summary as 0.0.0.0 after a few seconds. I set it up, hit save and it shows both IPs in WAN1 and WAN2...as fast as i can refresh it, it will show WAN2 back to 0.0.0.0
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...