RV320 intermittant signal degradation (running latest firmware - 1.1.0.06)
I have an RV320 that was upgraded to 1.1.0.06 in January. It ran on the previous firmware for a month no issue, then started to have signal degradation to the point it was unusable.
After the firmware update in Jan, all was well for 5 months. As of today - is having massive signal degredation again. Have read some threads and turned off bonjour and have no VPN. Only a couple of rules in for RDP and a static WAN are set on the router.
It's operating in a room that is under 25 degrees with airflow. Any ideas what is causing this?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...