How do I force the router to use WAN1 till it's saturated, and ther switch to WAN2 when needed. I've already configured the bandwidth correctly for each WAN, but it seems that some clients use WAN1, others use WAN2, disregarding the fact that they should use WAN1 as primary and the bandwidth it's not saturated by any other client.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...