Does someone know how to configure the RV320 to forward from external interface to internal IP higher than 30?
The problem in details:
RV320 with latest firmware (1.1.1.06)
on WAN interface a official fix IP to use some services with NAT
on local net (192.168.163.x) some services on different machines I will use from everywhere
I configure some services:
3389 RDP on server machine (ip.9)
33891 RDP1 on client 1 (ip.28)
33892 RDP2 on client 2 (ip.143)
33893 RDP3 on client 3 (ip.218)
When I configure RDP and RDP1, no problem, no error message. RDP to this machines is working fine. But when I want to configure RDP2 to machine with IP 192.168.163.143 I get a error message: "Private IP address should be under 192.168.163.1~30!"
Ok, "should", but is there a way arround this limitation? Some ideas? Many thanks for... no way to reconfigure the addresses.
I was not able to recreate the issue. I managed to create port forwarding rule for IP such as 192.168.20.30 as well as 192.168.20.130. Perhaps I am missing something in my test or you might need consider factory default reboot.
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...