RV320 restart and behave unstable after failover from WAN to USB3G modem.
I've setup a RV320 router with a 500Mbps internet link and a 3G modem in Hot standby mode.
But when I try to unplug the WAN and it failover to the 3G internet connection, the RV 320 behave very unstable and it frequently either
1. crash and restart and end up not able to access via webgui without network connectivity(All Led still remains on).
2. Fail over to 3G, works for a period of time, crash and restart.
For recover back from 3G modem to WAN, it usually able to fall back to WAN but crash and restart after a period of time, sometime after it restarted, the RV320 no longer respond, and webgui not available again. even it has down, all LED remains on and it looks still functioning.
Do you encounter similar problem and how do you fix it?
Can anyone from Cisco can help to fix this in next version firmware? I'm ok to help collect information from my RV320 for troubleshoot the problem.
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...
Article ID:541 Firmware Upgrade on RV016, RV042, RV042G, and RV082 VPN
Routers Objective To upgrade the firmware, a specific file must be
downloaded from the Internet and uploaded to the device. Firmware
upgrades can fix software bugs, improve features, a...