Can I configure the RV320 with an USB 3G/4G Modem on the WAN Side without getting hide behind the public IP ?
My LTE Provider will push an public (unnated) IPv4 to the USB 3G/4G Modem. I will configure a public IPv4 Network on the LAN side. This public IPv4 Network will be routed via the public IPv4 on the USB 3G/4G Modem. In case of an Hide-NAT my "inside" public IPv4 Adresses can't be used "normal". Is it possible to use the USB 3/4G only routed ? Any Experiences from the community about that ?
no - it's not possible with this hardware. Figured it out month ago. Cisco has NAT with all known LTE Hardware and it can't work disabled. Solution with other hardware is possible: fixed IP adress on SIM Card with routed IPv4 public network works fine ...
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...