Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

RV320 - Using Specific WAN Setting

Hi All,

I am new to RV320 and I would like to know that how can I set an IP address using specific WAN (say Wan 1) connection when load balance is enable.

Thanks,

Eric

1 REPLY
Cisco Employee

Hi Eric, You should be able

Hi Eric,

 

You should be able to achieve it by using protocol binding settings:

Dual WAN--> click on WAN (1 or 2) icon --> scroll down to protocol binding --> add specific rule for all services where source IP address would be your particular LAN host IP (repeated twice if it is only 1 host) and destination 0.0.0.0 (repeated twice) choose desire WAN1 or WAN2.

 

I hope this helps,

Aleksandra

111
Views
1
Helpful
1
Replies
CreatePlease to create content