We have an RV320 routes which we use for accessing our customers network. We have an VPN connection and we can't get it to work. We would need to masquerade traffic from our side so that they see the traffic coming from one public IP address. Currently they that the traffic is coming from our NAT'ed IP addresses. Can this be done with RV320?
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...
Article ID:541 Firmware Upgrade on RV016, RV042, RV042G, and RV082 VPN
Routers Objective To upgrade the firmware, a specific file must be
downloaded from the Internet and uploaded to the device. Firmware
upgrades can fix software bugs, improve features, a...