I have a RV320 router with dual WAN set up, but since I have an ATT Aircard (motorola Aircard 781S) I hoped to configure the router to use the aircard in the catastrophic event that both our Cable and Uverse ISPs go down.
The router sees the modem but is asking for a PIN number. I have contacted ATT and they gave me two PUK numbers but when I hit SAVE it just kicks me back to the previous level menu and gives the message shown :
USB modem is connected, but it requires correct PIN code to enable the USB service.
any ideas? has anybody configured this sucessfully?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...