I have a rv325 dual wan router. I have setup load balancing on the router, but I don't want one of the servers here being load balanced. How do i set it to only use a specific WAN while everything else is load balanced?
I like to share link that will has a step by step screenshots on how to configure protocol binding. Your source ip will be server and Destination is whichever WAN you are shaping that traffic. Hope this helps
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...