Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RV325 to RV320 gateway to gateway ipsec vpn - can't connect

IP on both ends.  Basically, RV325 local setting == RV320 remote setting for IP, subnet, etc.  Group1, group 2 etc... are identical.

Click on 'connect' and a few seconds later its back to waiting.  No errors or information.

Can anyone tell me where I'm going wrong?

Here is the syslog after hitting connect:

2016-02-02, 18:08:57 Kernel kernel: wrong ip[0],not_list[0]
2016-02-02, 18:08:57 Kernel kernel: upnp idx=76, ip=192.168.1.106, eport=5691, iport=5691
2016-02-02, 18:08:57 Kernel kernel: upnp idx=65, ip=192.168.1.106, eport=5691, iport=5691
2016-02-02, 18:10:23 VPN Log [g2gips0]: [Tunnel Disconnected]
2016-02-02, 18:10:24 User Log

gateway_to_gateway.htm is changed.

IP is correct on both local and remote.

2 REPLIES
New Member

Hi maugustyn1,

Hi maugustyn1,

did you find a solution at your problem ? I have the same problem and can't figure out what's wrong.

The poor logs don't help.

Thanks.

New Member

I was trying to connect to a

I was trying to connect to a remote (rural dsl) location and either the ping or the bandwidth was to slow.  Upped the speed to 5mbps (max available) and problem went away.

No thanks to the uninformative log information.

222
Views
0
Helpful
2
Replies