I have a new RVN220w that I am trying to get setup. I need to have a vpn connection working through the device but after a short period anywhere from a couple of minutes to an hour the device will stop responding to pings on the wan side and the vpn connection will stop. I have the wan side setup to a static IP address from a DSL router. This router also runs our VPN connection through a cisco 1811W router which is on the way out ( the wireless nolonger works but the vpn connection still goes). I have have updated the 220 to the the latest firmware () and tried turning off fragment packets and flood mode in the fire wall with no luck. When the device is up and working I can get the SSL vpn, quickVPN and PPTP style connections to work fine. But eventually the wan side will stop responding.
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...