Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RVS-4000 V1.3.2.0 Error Message? Dead loop on virtual device sit1, fix it urgently!

People,

Looks like I have  another cryptic message from my RVS-4000 V1.3.2.0:

Jun 13 16:54:50  -  Dead loop on virtual device sit1, fix it urgently!

Jun 13 16:54:53  - Dead loop on virtual device sit1, fix it urgently!

Jun 13 16:54:59  - Dead loop on virtual device sit1, fix it urgently!

Remember, my RVS-4000  is setup for 0-3 Log Levels:

Log Level

Setting which  level log Router should recorder. Level from 0 ~ 7 means:

0:  LOG_EMERG(system is unusable)

1: LOG_ALERT(action must be taken  immediately)

2: LOG_CRIT(critical conditions)

3:  LOG_ERR(error conditions)

4: LOG_WARNING(warning conditions)

5:  LOG_NOTICE(normal, but significant, condition)

6:  LOG_INFO(informational message)

7: LOG_DEBUG(debug-level message)

So, when I  get any messages... I'm a little concerned. Because the RVS-4000 V1.3.2.0 thinks  it's an Error or better.

Thanks ahead of time!

Bruce :-|

2 REPLIES
New Member

Re: RVS-4000 V1.3.2.0 Error Message? Dead loop on virtual device

I was receiving this message too.   Until I set IP Mode to IPv4 Only.  Error messages stopped.

This may not be very helpful if you need IPv6.  But I suspect you don't because I think this error message implies that something is very wrong with IPv6 configuration.  If you needed it, you'd have noticed that it wasn't working.   Look here: http://linux.die.net/man/8/isatapd

Surely there are other ways to say whatever it is this message is saying so I think it is probably safe to assume it is the exact same code that generated the error for the same reason.

New Member

Re: RVS-4000 V1.3.2.0 Error Message? Dead loop on virtual device

Thank you for this information...

I will try turning IPV6 off.

Bruce

2036
Views
0
Helpful
2
Replies